ENERpower battery LiFePO4 24V (25.6V) for the operation of 24V devices, motors, wheel chairs etc. Important general informationWe assemble this series of LiFePo4 batteries in the 8S (25.6V) format with battery cells from Haidi. All battery cells have important safety certifications such as UL and IECOur batteries are light (compared to lead acid batteries) and can reach up to 2000 charging cycles.The batteries are manufactured with 2 outputs (charging / discharging). For charging (up to 8A charging current) we use an XLR-3 connector. For unloading you can choose between XT-60, XT-90 or Anderson PowerPoleYou can purchase the battery with 2 different BMS's:1. Up to 15A continuous load - for devices with a consumption of up to 370 watts2. Up to 30A continuous load - for devices with a consumption of up to 740 wattsThe protection against overcharging (29.4V) and against deep discharge (16V) avoids damage to the battery and increases the safety factor.We manufacture these batteries with a charge status indicator so that you can see the charge status of the battery at any time. highlights High-quality production in Germany BMS with an integrated passive balancer BMS with protection against overcharging, deep discharging, overdischarging (temperature monitoring) Direct from the manufacturer Rechargeable - Still 80% of original capacity after 1800 full charge cycles No memory effect - charge the battery whenever you want Environmentally friendly according to EU directive 2002/95/EG (RoHS) Technical specifications  Voltage (nominal): 24V (25.6V) Capacity: 28Ah Configuration: 8S7P Energy: about 717Wh Maximum charging current: 8A Internal resistance: < 70mOhm Charging voltage: 29.2V End-of-discharge voltage: 16V Weight: approx. 5.2 kg. Charging: XLR-3 Discharge: XT-60 / XT-90 / Anderson PowerPole Dimensions: ca. 225 x 200 x 70 mm

ENERpower Softpack battery 24V in format 7S5P | 360Wh | capacity 15Ah | for Pedelecs, eBikes DIY, Electric Boats, Maschines, Robotics | with Samsung 30T. Important General Information This 24V battery in softpack is in 7S format (25.2V-25.9V) and is manufactured with the battery cells of Samsung SDI, Murata (Sony) or Panasonic. The batteries are manufactured in cell holders made of plastic and equipped with a BMS 40A brand ENERpower. Charging is made with a spiral cable (20 - 100 cm extendable) with a XLR-3 (3 pins) connector. Discharging is realized via a discharge cable with XT90 connector (male). A counterpart XT90 is also included.   This range of small and powerful batteries we assemble with the impressive cell of Samsung SDI INR21700-30T. This battery cell hold a very stable voltage also at high discharge current and can operate 24V devices with up to 1200 Watt consumption.  Thus, this battery is also suitable for motors with 1200 watts of power.We manufacture the softpack batteries with FR4 insulation, flame retardant and flame retardant composites consisting of epoxy resin and glass fiber fabric. FR-4 is used inter alia as an electrically non-conductive substrate in electrical circuit boards. Compatible with 24V motors 250 watts / 350 watts / 500 watts / 750 watts / 1000 / 1200 watts Highlights High-quality production - Made in Germany Production Just-In-Time BMS with an integrated passive balancer and protection against overcharge, over-discharge, over-discharge (temperature monitoring) Direct from the manufacturer Rechargeable - After 300 charging cycles, still maintains 80% of the original capacity No memory effect - charge the battery whenever you want Environmentally friendly in accordance with EU Directive 2002/95 / EC (RoHS) Technical Specifications Li-ion battery cell: Samsung SDI INR21700-30T Voltage (nominal): 24V (25.2V – 25.9V) Capacity: 15Ah Energy: approx. 360 Wh Configuration: 7S5P Format: 7 × 5 Internal resistance: < 75 mOhm Charging voltage: 29.4V End-of-discharge voltage: 21V Continuous discharge current: 50A = 1200 Watt 5 Sec. discharge current: 60A = ca. 1440 Watt Charging: up to 8A Discharging temperture: -20 to 80°C Weight: approx. 2.75 kg. Dimensions Length: 160 mm Länge Width: 115 mm – 135 mm Height: 70 mm

ENERpower soft-pack battery 24V in format 7S3P | Capacity 15Ah | for Pedelecs, eBikes DIY | with Samsung SDI INR21700-50E Important General Information The 24V batteries (25.2V - 25.9V) in softpack are manufactured in Berlin, and assembled in cell holders made of plastic. Charging is daone with a 3-pin charging plug (XLR-3), discharging via a discharge cable with XT-90 connector (male). A fuse of 30A in a waterproof holder limits the current drain.The BMS (Battery Management System) is always mounted on the longest side of the battery. At this point, the battery is about 10 to 15 mm thicker.The softpack batteries are assembled with FR4 insulation, which is made of flame retardant composite materials and consists of epoxy resin and glass fiber fabric. FR-4 is used i.a. as an electrically non-conductive substrate in electrical circuit boards.   The INR18650-30Q can be discharged up to -20 Degrees, Charging at > 0 Degrees Compatible with 24V motors 250 Watt / 350 Watt / 450 Watt Highlights High-quality production - Made in Germany Production Just-In-Time BMS with an integrated passive balancer and protection against overcharge, over-discharge, over-discharge (temperature monitoring) Direct from the manufacturer Rechargeable - After 300 charging cycles, still maintains 80% of the original capacity No memory effect - charge the battery whenever you want Environmentally friendly in accordance with EU Directive 2002/95 / EC (RoHS) Technical Specifications Li-ion cell: Samsung SDI INR21700-50E Voltage (nominal): 24V (25.2V - 25.9V) Capacity: 15 Ah Power: approx. 375 Wh Configuration: 7S3P Construction: 7 x 3 Internal resistance: < 75 mOhm Charging voltage: 29.4V End-o-fdischarge voltage: 21V Continuous discharge current: 20A = 480 watts 10 min. discharge current: 25A = 600 watts 5 seconds discharge current: 35A = approx. 850 watts Weight: Approx. 1.55 kg. Dimensions Length: 140 mm Länge Width: 100 mm – 115 mm Height: 70 mm

ENERpower Softpack battery 24V in format 7S6P | 440Wh | capacity 18Ah | for Pedelecs, eBikes DIY, Electric Boats, Maschines, Robotics | with Samsung 30T. Important General Information This 24V battery in softpack is in 7S format (25.2V-25.9V) and is manufactured with the battery cells of Samsung SDI, Murata (Sony) or Panasonic. The batteries are manufactured in cell holders made of plastic and equipped with a BMS 40A brand ENERpower. Charging is made with a spiral cable (20 - 100 cm extendable) with a XLR-3 (3 pins) connector. Discharging is realized via a discharge cable with XT90 connector (male). A counterpart XT90 is also included.   This range of small and powerful batteries we assemble with the impressive cell of Samsung SDI INR21700-30T. This battery cell hold a very stable voltage also at high discharge current and can operate 24V devices with up to 1200 Watt consumption.  Thus, this battery is also suitable for motors with 1200 watts of power.We manufacture the softpack batteries with FR4 insulation, flame retardant and flame retardant composites consisting of epoxy resin and glass fiber fabric. FR-4 is used inter alia as an electrically non-conductive substrate in electrical circuit boards. Compatible with 24V motors 250 watts / 350 watts / 500 watts / 750 watts / 1000 / 1200 watts Highlights High-quality production - Made in Germany Production Just-In-Time BMS with an integrated passive balancer and protection against overcharge, over-discharge, over-discharge (temperature monitoring) Direct from the manufacturer Rechargeable - After 300 charging cycles, still maintains 80% of the original capacity No memory effect - charge the battery whenever you want Environmentally friendly in accordance with EU Directive 2002/95 / EC (RoHS) Technical Specifications Li-ion battery cell: Samsung SDI INR21700-30T Voltage (nominal): 24V (25.2V – 25.9V) Capacity: 18Ah Energy: approx. 440 Wh Configuration: 7S6P Format: 7 × 6 Internal resistance: < 75 mOhm Charging voltage: 29.4V End-of-discharge voltage: 21V Continuous discharge current: 50A = 1200 Watt 5 Sec. discharge current: 60A = ca. 1440 Watt Charging: up to 8A Discharging temperture: -20 to 80°C Weight: approx. 3.35 kg. Dimensions Length: 160 mm Länge Width: 138 mm – 160 mm Height: 70 mm